Officeconnect Remote 812 Boot Mode Options; Option One: Dhcp Smart Mode - 3Com OfficeConnect 3CP4144 Get Started Manual

OfficeConnect Remote 812 Boot Mode Options

OfficeConnect Remote 812 Boot Mode Options
To simplify the installation process, the Remote 812 can be
initialized with pre-configured parameters using the DIP
switches located on the back of the unit. There are three
Boot Mode options:
DHCP Smart Mode


Default Bridge Mode


Unconfigured Mode


It is important to note that these boot modes only take
effect if the unit has not been previously configured. To
erase the existing configuration, reference Appendix A.
The DIP switch settings and the corresponding Boot Mode
option are as follows:
Table 1-1 DIP Switch Settings
1 2
off on
off off
off off
off off

Option One: DHCP Smart Mode

You can use the DHCP Smart Mode if:
You plan on using private addresses on the LAN (i.e.


your Service Provider has provided you with only 1
public IP address),
You plan on using the Remote 812's DHCP Server


The Remote 812 will power up with the following "DHCP
Smart Mode" configuration:
LAN IP address = 192.168.200.254, Netmask


255.255.255.0.
DHCP IP address pool (40 addresses): 192.168.200.1-40


DNS name: ocrdsl-3com.com.


3 4 Mode
off off DHCP Smart Mode
on off Default Bridge Mode,
VPI=0, VCI=35
off on Default Bridge Mode,
VPI=8, VCI=35
off off Unconfigured Mode
1-3