Operation - WilTec DBHC001 Operation Manual

Replace worn and damaged parts in sets to avoid unbalance.
•

Operation

Before switching on the machine, look into the filling chamber to ensure that it is empty.
•
Do not insert hands or other parts of the body into the hopper or ejection chute.
•
Always ensure a safe stand and good balance. When filling the machine, never stand on a
•
higher level than the surface on which the machine stands. When operating the machine, al -
ways keep far enough away from the ejector.
When filling the machine, always ensure that no pieces of metal, stones, surfaces, cans or
•
other foreign objects are inserted. If the cutting mechanism touches a foreign object or if the
machine makes unusual noises or vibrations, switch off the power immediately and let the ma-
chine run out completely or come to a standstill. Disconnect the machine from the power sup-
ply and carry out the following measures in the specified order:
Check the machine for possible damage.
◦
Then make sure that all loose parts have been tightened and that all components are se -
◦
curely fastened.
Each damaged component must be replaced with original spare parts with identical spe-
◦
cifications.
Do not allow the processed material to accumulate in the ejection area, as this may interfere
•
with correct ejection or cause the material to recoil through the feed opening. If the machine
starts to clog, immediately disconnect it from the power supply. Before removing the blockage,
the shredder MUST be disconnected from the power supply.
Keep the power unit free of waste and other debris to prevent damage or possible fire. Always
•
remember that the cutting tools continue to move for a while even after the machine has been
switched off. Always wait until the machine has come to a complete standstill.
Do not change the motor controller settings! The controller controls the safe maximum operat -
•
ing speed and protects the engine and all moving parts from damage caused by excessive
speed.
Always switch off the shredder as soon as you leave the working area. Always consult a spe -
•
cialist operator or customer service if you have a problem.
Never tip the machine when the engine is switched on.
•
Never operate the machine with defective guards or without safety devices such as the at-
•
tached collecting tank. If the cables are damaged, stop operation!
Warning! The maximum permissible mains impedance Z
of the device is 0.333 Ohm. As the user of this device, you must consult the power supply com-
pany in case of doubt. The device may only be connected to a power supply whose impedance
is less than or equal to Z
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
!
max
Item 61075
(total alternate current resistance)
max
Page 10
12 2020-1