Table of Contents
Advertisement
Maintenance and storage
If the machine is switched off for maintenance, inspection, storage or replacement of an ac-
•
cessory (power unit MUST be disconnected in such cases), make sure that all moving parts
are stationary and any keys have been removed. Allow the machine to cool down before any
inspection, adjustment, storage, etc.
Maintain the machine with care and keep it clean at all times. When maintaining the chaff unit,
•
be aware that although the energy source is switched off due to the interlocking function of the
protective device, the chaff unit can still be moved. NEVER try to bypass the interlocking func-
tion of the guard!
When servicing the cutting tools, make sure that (even if the power source cannot be switched
•
on due to the safety lock) the cutting tools can still be switched on by a manual start mechan-
ism.
Additional safety instruction for devices with collecting containers
The chopper must always be switched off before attaching or removing the collecting container!
Residual risk
Even when used as intended, residual risks may still exist despite compliance with all relevant
•
safety regulations due to the design determined by the intended use.
Residual risks can be minimized if the safety instructions and the intended use as well as the
•
operating instructions as a whole are observed. Consideration and caution reduce the risk of
injury or damage to property:
risk of injury to fingers and hands if you reach with your hand through an opening and
◦
reach the knife mechanism;
risk of injury to fingers and hands during assembly and cleaning work on the knife mech-
◦
anism;
injury due to chaff being thrown away in the area of the funnel;
◦
danger from electricity if incorrect electrical connection cables are used;
◦
contact with live parts when electrical components are open.
◦
In addition, prolonged work without hearing protection may result in hearing loss or damage.
•
Despite all precautions taken, there may be non-obvious residual risks.
Extension cable
Only use extension cables approved for outdoor use (H05VV-F). The cable cross section must be
equal to or greater than 1.5 mm² for a length of up to 75 m. Extension cables longer than 30 m gener-
ally reduce the performance of the machine.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61075
Page 11
12 2020-1
Advertisement
Table of Contents
