Care And Maintenance - WilTec DBHC001 Operation Manual

If garden waste that has already become slightly damp and rotten is to be disposed of, switch
•
between garden waste and branch plant during filling to avoid blocking the cutting blade. Com-
post soft kitchen waste and DO NOT put it into the shredder.
Branches with leaves must have passed completely through the shredder before new material
•
can be added. Please make sure that the shredded material can fall freely into the collecting
basket without blocking the outlet. The ventilation slots must not be blocked by the chopped
material (covered/clogged/soiled).
Longer chipping of thick wood or strong branches can cause the machine to stop due to clog-
•
ging or jamming. Soft material such as leaves or small twigs can easily clog the feeder. Use a
stick to push in this material.
Waste material must always be inspected for nails, stones and other solids beforehand, as
•
such objects can seriously damage the shredder.
Beware of vibrations, as these are usually a typical sign of worn or damaged cutting blades.
•
Always replace the cutting blades if necessary.

Care and maintenance

WARNINGS!
Make sure that the garden shredder is switched off and disconnected from the mains
•
before carrying out any cleaning or maintenance work on the machine. Always wear
sturdy protective gloves when cleaning the cutting blades!
Risk of injury from moving and dangerous parts!
•
To maintain the efficiency of the shredder, it must be kept clean. Clean the shredder after
•
each use!
Do not allow shredded material to dry or harden on the surfaces of the shredder. This has an
•
immediate negative effect on the shredding performance.
Always ensure a clean filling and ejection chute free of waste material.
•
Always make sure that all nuts, bolts and screws are tight!
•
Always have defective and worn parts repaired or replaced by qualified personnel.
•
Do not use cleaning agents or solvents as they may cause irreparable damage to your ma -
•
chine. Chemicals can destroy plastic parts.
After every fourth or fifth use, the knives must be oiled!
•
Spare parts order
When procuring spare parts, the following information should be provided:
Device type
•
Device item number
•
Device identification number
•
Cutting tools (knives): GY1
•
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61075 Page 15
12 2020-1