Listening To The Other External Components - Kenwood KDC-315R Instruction Manual

Discs that cannot be used
Discs that are not round.
Discs with coloring on the recording surface or discs that are dirty.
You cannot play a Recordable/ReWritable disc that has not been finalized. (For the
finalization process refer to your disc writing software, and your disc recorder instruction
manual.)
3-inch CD cannot be used. Attempt to insert using an adapter can cause malfunction.
Listening to the other external
components
Preparation : Make sure [ON1] or [ON2] is selected for [BUILTIN AUX]. (page 4)
1 Press SRC to select "AUX."
2 Turn on the external component and start playing.
3 Turn the volume knob to adjust the volume.
Maintenance
Cleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure to
observe this precaution may result in damage to the monitor or unit.
Cleaning the connector: Wipe off dirt on the connector of the unit and faceplate. Use a
cotton swab or cloth.
Handling discs
Do not touch the recording surface of the disc.
Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
Do not use any accessories for the disc.
Clean from the center of the disc and move outward.
Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
When removing discs from this unit, pull them out horizontally.
Remove the rims from the center hole and disc edge before inserting a disc.
3.5 mm stereo mini plug
(optional accessory)
Auxiliary input jack
Portable audio device
(optional accessory)
9