Maxon 297072-01 Instruction

Bmra filter line field fix

LIFT CORPORATION Sht. 1 of 3 DSG#

INSTRUCTION, BMRA FILTER LINE FIELD FIX

NOTE: This ﬁ eld ﬁ x kit is used to replace the steel line on the oil ﬁ lter outlet

in BMRA and BMRSD pump boxes. It applies to gravity down,

power down, single pump, and dual pump models.

HOSE, 1/2" MP, JIC#8F TO JIC#8F

To prevent accidental personal injury and equipment damage, make sure

power is disconnected from Liftgate while installing parts.

1. Turn OFF the master disconnect switch at the pump

box to disconnect battery power from the hydraulic

pumps. Refer to BMRA Operation Manual for

detailed instructions.

KIT P/N 297072-01

P/N 297071-01

QTY. 1

WARNING

M-16-06

Rev. - Date: 02/22/16

STRAIGHT FITTING

#6 O-RING, M-M JIC#8

P/N 253701

QTY. 1

45º ELBOW, JIC 37º

#8M - NPT #6F

P/N 906965-01

QTY. 1

Table of Contents

Do you have a question about the 297072-01 and is the answer not in the manual?

Page 1 Liftgate while installing parts. 1. Turn OFF the master disconnect switch at the pump box to disconnect battery power from the hydraulic pumps. Refer to BMRA Operation Manual for detailed instructions. © MAXON Lift Corp. 2016...
Page 2 90º elbow from reservoir 90º (FIG. 2-2). Then, remove the 90º elbow ELBOW from oil ﬁ lter outlet (FIG. 2-2) FILTER HYDRAULIC 90º ELBOW RESERVOIR LINE REMOVING HYDRAULIC LINE & 90º ELBOWS (SINGLE HYDRAULIC PUMP SHOWN) FIG. 2-2 © MAXON Lift Corp. 2016...
Page 3 CONNECTING NEW HYDRAULIC HOSE (SINGLE HYDRAULIC PUMP SHOWN) 9. Reconnect battery power to the FIG. 3-2 hydraulic pumps by turning ON the master disconnect switch at the pump box. Refer to BMRA Operation Manual for detailed instructions. © MAXON Lift Corp. 2016...