Connecting Cables To Terminals - Kenwood KDC-6060R Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
A–4 Pin
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
+
Rear Right ( )
–
Rear Right ( )
+
Front Right ( )
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
(Yellow)
8 6
Connector A
7 5
8 6
Connector B
7 5
FM/AM antenna input
Antenna Cord (ISO)
Antenna Conversion Adaptor (ISO–JASO)
KENWOOD disc changer/DAB control input
NOTE
To connect the Disc changer or DAB unit, consult each manual.
Rear left output (White)
Rear right output (Red)
Fuse
Wiring harness
(Accessory1)
TEL mute cable (Brown)
TEL MUTE
Power control/ Motor antenna
control cable (Blue/White)
P.CONT.OUT
4 2
If no connections are made, do
3 1
not let the cable come out from
the tab.
4 2
3 1
— 38 —
(Accessory4)
Connect to the terminal that is grounded when
either the telephone rings or during
conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.