Table of Contents
Advertisement
SH SOLAR E, D
3.8 High pressure connec-
tion
8
• Guide the supply cable
through the strain relief grom-
met on the frame (9) and
through the strain relief grom-
met on the electric box into
the electric box.
• Connect the phase cords of
the supply cable to the con-
nection terminals L1(1), L2(3)
and L3(5) of the main switch
of the machine. For single
phase machines use L1(1)
and L2(3) to connect phase
and zero cords.
• Connect protective earth
wire to the terminal marked
and located above the main
switch on the metal chassis
(6). Ensure the connection by
the use of toothed washers.
1
a
• Check and measure the
• Connect the other end of the
Make sure that the cable is
properly guided and relieved
between the fi xed installation
and the machine and that the
cable is without any damage to
the insulation.
Also see notes in section "1
Safety precautions and war-
nings"!
The outlet of the machine (1)
can be connected directly to a
standard high pressure hose (a)
or to a pipeline with fi xed outlet
points (c).
c
IMPORTANT: When connecting
to a pipeline always use a fl ex-
a
ible hose connection from the
outlet of the machine (pos. 1).
Contact your Nilfi sk distributor
for further information about
hose dimension.
It is recommended to let a ser-
vice tech ni cian authorized by
Nilfi sk prepare the pipeline.
protective earth connection
according to legislation.
cable to an approved socket
of a correct dimensioned
main supply.
Original Instructions
Advertisement
Table of Contents
