Table of Contents
Advertisement
SH SOLAR E, D
4.2.2 Automatic start/stop
4.2.3 Running with hot water
16
The machine is equipped with
a heating source (electrical, or
diesel driven) to heat the water.
The heating source can be
switched on or off at conveni-
ence by pushing the yellow
"Heating" push button (5). Push-
ing the button once will turn
on the lamp in the button and
switch ON the heating source.
Pushing the button again will
turn out the lamp in the button
and switch OFF the heating
source.
5
4
3
8
On the D-model the tempera-
ture can be adjusted within the
limits stated on the "Thermo-
stat" (8), by turning the knob
to the desired value. When the
heating source is ON (push but-
ton (5) alight), the preset and
the actual outlet temperature
of the water can be read on the
display. The control unit of the
Always hold the spray lance
with both hands!
The machine will automatically
start when the trigger (1) of the
spray handle is activated and
will automatically stop and enter
standby mode when the trigger
is released. If the handle has
not been activated within 20
seconds, the machine will enter
1
stand-by mode.
When the machine is not in
use, the trigger should be lo-
cked with locking device.
machine will monitor the water
temperature and regulate the
SET TEMP.
70 C
CURRENT TEMP
40 C
heating source to provide the
preset temperature.
On E-models, with heating
tanks on the suction side of the
high pressure pump, heating
will be performed indepen-
dently of the spraying operation
- "Working mode" as well as
"Standby mode". The tempera-
ture is controlled by a tempera-
ture sensor in the water tank.
Thus the water will always be
preheated to the desired value
– ready for use when the spray
handle is activated.
On D-models heating is per-
formed by a burner in a pres-
surized boiler. Heating is
controlled by a thermostat on
the outlet of the boiler when
water is fl owing out of the ma-
chine – "Working mode". As the
Original Instructions
ESC
+
-
OK
Advertisement
Table of Contents
