Table of Contents
Advertisement
SH SOLAR E, D
7.2 Errors messages, E (electrical heated) models
If heating cannot be switched on or is switched off without any error messages, it is likely that the
overheat protection (pos. 11 on fold out page) has tripped. Unscrew the dust cap, and push the rod to
reset the overheat protection switch. If this error re-occurs, call Nilfi sk service.
Error Message
(red STOP light fl ashing)
Pump oil level low
E3
Water shortage
E1
Motor cut out
E10
28
Reason
> Level of lubricant oil of HP
pump is at a low level
> Lack of water in heating tank
> Motor is not running
> Missing phase in your instal.
> Overload or short circuit of
the machine.
Action
• Remove cabinet and top up
oil if no leakage is present.
• Call Nilfi sk service if oil is
leaking or if water is mixed in
the oil (creamy white or
transparent)
• See section "3.8 Venting"
• Check your water supply
– open?, suffi cient pressure?
• Check and clean inlet fi lter,
section 6.3.
• Motor overheated – let
the machine cool down and
retry. Check pressure and
check nozzle size and clean
nozzle if necessary.
• Cooling of motor disturbed
– call Nilfi sk service.
• Call authorized electrician.
• Call Nilfi sk service.
• Other motor problems – call
Nilfi sk service.
Original Instructions
Advertisement
Table of Contents
