Table of Contents
Advertisement
6.3 Water fi lter
6.4 Cleaning of high pres-
sure nozzle
6.5 Fuel fi lter - D-models only
6.6 Disposable waste
Original Instructions
A clogging up in the nozzle will
cause the pump pressure to in-
crease above normal operating
pressure, and cleaning of the
nozzle is required immediately.
1. Stop the cleaner and detach
the spray lance.
2. Clean the nozzle with the
cleaning tool.
This high pressure hot water
washer consists of parts which
can affect the environment
when thrown away. Parts that
can pollute are as follows:
Oil, painted/zinc-coated parts,
plastics/plastic-coated parts.
Therefore, it is important to
follow the laws concerning the
removal of polluting and dan-
gerous materials when replac-
ing spare parts or disposing of
high pressure hot water washer.
To avoid debris entering the
high pressure pump, a water
fi lter (fi ne) is fi tted at the wa ter
inlet. Dependent on the purity of
7
the water, this fi l ter will have to
be cleaned at regular in ter vals.
The fi lter can be removed when
the quick coupling (7) has been
un screwed.
IMPORTANT: ONLY use the
cleaning tool when the spray
lance is detached.
3. Flush the spray lance back-
wards with water.
4. If the pressure is still too
high, repeat items 1-3.
Remove the cabinet to gain ac-
cess to the fuel pump.
1. Clean fi lter:
Unscrew fi lter cap (1).
2. Clean/replace fuel fi lter (2).
3. Dispose of cleaning solu-
tion/damaged fi lter in ac-
cordance with the disposal
regulations.
It is recommended that you
bring the rejected parts to
waste disposal areas or recy-
cling plants that are approved
for the destruction of these
types of materials.
SH SOLAR E, D
25
Advertisement
Table of Contents
