Before Loading The Machine And Before Starting A Programme; Rinse Nozzle For Powder Dispenser - Miele A 300/2 Operating Instructions Manual

Before loading the machine and before starting a
programme
– Check that fittings such as irrigation sleeves and injector nozzles
are securely screwed into position.
 Make sure that all screw connectors are fitted with injector
nozzles, adapters, irrigation sleeves or blind stoppers to ensure
that all fittings in use are supplied with sufficient standardised
pressure.
Damaged fittings such as injector nozzles, adapters and irrigation
sleeves must not be used.
Fittings not equipped with wash items do not have to be replaced
blind stoppers.
– Check that the baskets and modules are correctly connected to the
water supply.

Rinse nozzle for powder dispenser

If powder cleaning agent is used in combination with an upper basket
and two modules in the lower basket in the case of cleaning ma-
chines with a powder dispenser  in the door, an A 802 rinse nozzle
for powder cleaning agent must be fitted.
This rinse nozzle flushes the powder cleaning agent out of the dis-
penser during reprocessing.
If liquid cleaning agent is dispensed, a rinse nozzle is not required.
The rinse nozzle must be fitted at the front left of the left-hand module
in the lower basket:
Release the existing nozzle using a spanner and remove it.

Screw the rinse nozzle into the free holder and tighten with the

spanner. The rinse opening must then be pointing forwards.
Load items must not be attached to the rinse nozzle.
en - Areas of application
59