Assa Abloy Corbin Russwin IN220 PoE Installation Instructions Manual page 18

IN220 Cylindrical Lock
10. Installation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Secure the following connectors to their respective terminals (Fig. 10a):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
*NOTE: Optional 2-pin external 12-24VDC power connector.
IMPORTANT: Do not run wires through hole in plate - this
will damage wires and the controller connector.
Route wires around flange, do not route wires through the
flange hole (Fig. 10a, b, c).
Secure Mounting Plate
1. Tuck excess cable into wire hole on inside of door.
2. Secure the mounting assembly while ensuring proper
alignment of outside reader and fully tighten the (2) through-
bolts on the inside of the door to secure the reader and plate
to the door.
C. Secure the 24-pin card reader connector (Fig. 10b).
D. Crimp* RJ45 to cat5e cable from hinge (Fig. 10c).
*For more detail, refer to section (5) 'Installation Wiring',
"A - Frame Harness Installation".
TIA/EIA 568-B Standard Wiring
pin
1
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
PIN
1 White/Orange
pin
8 8
1
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
Ground
Lugs
Board-to-Board
Connector
Wire Pair
Number
2
Crimp* to RJ45-M
2
3
1
1
3
4
4
18
DPS (4-pin)
A
C
Fig. 10a
Reader
C
(24-pin)
Fig. 10b
Connector
D
RJ45-M
Fig. 10c
12-24VDC
Power*
B
Lock
Body
(10-pin)
Cat5e cable
from hinge