Assa Abloy Corbin Russwin IN220 PoE Installation Instructions Manual page 13

IN220 Cylindrical Lock
6. Install Lock Body
a. Feed lock body and wire through 2-1/8" diameter hole from outside of door (Fig. 6a).
Be sure latch engages lock body as shown (Fig. 6b).
b. Connect 4-pin connector from lock body to 4-pin on
cassette (Fig. 6c).
c. Temporarily install top throughbolt to hold chassis in door (Fig. 6c).
Important: Door must remain open during installation.
Use door stop.
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
Outside Face of Door
Fig. 6a
Inside Face of Door
Fig. 6c
13
Fig. 6b
Spring Cassette