Siemens CP 1626 Operating Instructions Manual page 50

Operating hardware
4.3 Web server
directly adjacent to a configured PROFINET device. This device is indicated by a light
gray dashed line.
The status of PROFINET devices of a different PROFINET IO subsystem is not displayed
in the device header.
Views after changes to the setup
● If a device fails, this device remains in the "Set topology" view at the same position but
has a red border around the device head and a red wrench.
● After having failed, the device is displayed in the bottom area of the in the "Actual
topology" view. This error state is indicated by means of a device header with red frame
and a red wrench.
Link between the "Topology" and "Module information" Web pages
The two web pages, "Topology" and "Module information", are linked. A click on the header
of a configured communications processor in the topology view automatically takes you to
this communications processor on the "Module information" Web page.
See also section "Module information (Page 39)".
Topology -Table view
The "Table view" always shows the "Actual topology".
50
Operating Instructions, 11/2018, C79000-G8976-C434-03
CP 1626