Table of Contents
Advertisement
6 Shut Down Sensor and Tec Case
6 Shut Down Sensor and Tec Case
Multi Sensor or RF-100 breaks
By disconnecting the cable or shut down the Tec Case without shut down the sensor, the
sensor could break.
•
Always shut down the sensor in the DT Control Center before disconnecting the cable
or shut down the Tec Case.
Procedure:
Connect to the DT Control Center.
1
Choose menu OPTIONS > Site Configuration.
2
For each connected Multi Sensor and RF-100, right-click on the sensor symbol and
3
choose System > Shutdown Hardware.
In the header the message Network error, reconnecting... is shown.
The light of the blue button at the Multi Sensor or RF-100 turns off.
Push the blue button at the outside of the Tec Case.
4
The light of the blue button at the Tec Case turns off and the Tec Case is off.
Disconnect all cables from the Tec Case and the sensors.
5
Push the blue button inside the Tec Case.
6
The battery display in the Tec Case turns off and the Tec Case is shut down.
18
Dedrone
IM-Inst-EK2536en
Advertisement
Table of Contents
