Charge Tec Case - Dedrone DroneTracker Event Kit 2.5 Installation Manual

Table of Contents

Advertisement

Dedrone

5 Charge Tec Case

The charge of battery is shown at the battery display inside
the Tec Case. Turn on the main switch, to see the charge of
battery.
Green: Ready/standby
Orange: low state of charge, full functionality is not
guaranteed  charge the battery
Red: Battery is empty, shut down in next seconds.
 charge the battery
Procedure:
If possible, shut down sensors and Tec Case (see 6 Shut Down Sensor and Tec Case,
1
page 18).
Connect the battery charger to the socket
2
Connect the battery charger to the power supply.
3
Check that the main switch inside the Tec Case illuminates blue.
4
The LED at the charger shows the charging state:
Orange: boost charge, battery level < 90 %
Yellow: top-up charge, battery level 90 % - 100 %
Green:
The battery is charging.
The main switch is not illuminated?
 Check the screw connection at the Tec Case and tighten firmly.
IM-Inst-EK2536en
float charge, battery level 100 %, charger in standby
and tighten the screw.
5 Charge Tec Case
17

Advertisement

Table of Contents
loading

Table of Contents