Table of Contents
Advertisement
4 Set Up
4.4 Cable Requirements and Preparation (Crimp)
Cable Requirements
Type
Maximum Length
External Diameter
Cable Preparation
For a weather resistant LAN connection from your computer to the Tec Case, it is necessary to
crimp the supplied environmentally sealed Ethernet connector to the patch cable (not
included).
Cut the RJ45 plug off the laid cable. Keep the cut off plug, to check the wiring
1
standard later.
Thread the small gland nut, the bigger gland
2
nut and the connector body on to the cable.
Remove the cable jacket carefully. Therefore take care not to damage the braid and
3
foil.
Fold back the braid and foil over the cable jacket.
4
Note: 25 mm (1") of free conductors are needed.
Unravel the conductors, sort the conductors
5
in the required wiring standard (568-A or 568-
B) and push the conductors all the way in the
plug.
The required wiring standard can be checked
on the previous cut-off RJ45 plug.
Crimp the RJ45 plug with the crimping tool.
6
Push down the latching clip of the plug and press the connector body all the way to
7
the stop over the RJ45 plug.
Put the bigger gland nut over the connector body and screw down the small gland
8
nut on the connector body.
14
Cat-6 Patch Cable
Recommendation:
Cat-7 Patch Cable
328 ft (100 m)
For longer distances, a PoE extender is required
3.5 mm – 7.5 mm
Position
568-A
1
White/Green
2
Green
1
3
White/Orange
4
Blue
Front Face View
5
White/Blue
6
Orange
7
White/Brown
8
Brown
IM-Inst-EK2536en
Dedrone
568-B
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Advertisement
Table of Contents
