4 Set Up
4.3 Set Up autonomously
Requirements:
□
Check batteries and make sure that the electric connection is working.
Procedure:
Multi Sensor or RF-100 breaks
By overheating of the Tec Case, the Tec Case shuts down automatically and the sensor could
break.
•
Take care, that inside the Tec Case the temperature is not getting over 149 °F (65 °C), for
example by open the lid or providing shadow.
Turn on your notebook, set up the tripod, screw the tripod head on the tripod and
1
attach the Dedrone sensors to the tripods.
If you set up the RF-100, screw the antenna on
2
the screw threads at the top of the RF-100.
Therefor note the correct positioning of the
short and long antenna.
Turn on the main switch inside the Tec Case and
3
check the charge of battery at the battery display.
The battery display shows the charge of
battery:
o Green: ready/standby
o Orange: low state of charge, full
functionality is not guaranteed, charge
the battery (see chapter 5, page 17)
o Red: battery is empty, shut down in next
seconds.
Use the switch outside the Tec Case, to turn the power on.
4
Wait for 30 seconds, before following the next steps.
The router boots and is going to provide the Wi-Fi network and is preparing LAN
communication.
12
Dedrone
short
long
IM-Inst-EK2536en