Inserting And Removing Sd Cards; Inserting Sd Cards; Removing Sd Cards; Sd Card Write Protection Switches - Tascam 24 Manual

Inserting and removing SD cards

Inserting SD cards

Insert an SD card into an SD card slot on the top of the unit to enable
playback and recording by this unit.
NOTE
SD cards can be inserted whether or not the unit is on or off.
1.
Open the SD card slot cover.
2.
The SD card label should be facing left and the connector should
be inserted down.
3.
Close the SD card slot cover.

Removing SD cards

Turn the unit off or stop operation before removing an SD card.
CAUTION
Do not remove an SD card when the unit is operating (including play-
ing back or recording). Doing so could cause proper recording to fail,
data to be lost, and sudden loud noises from monitoring equipment,
which might damage the equipment, harm hearing or cause other
trouble.
1.
Press the SD card in gently to make it to come up.
2.
Pull the SD card out.

SD card write protection switches

SD cards have write-protection switches that prevent writing new data
to them.
If you slide the write-protection switch to the LOCK position, writing will
not be possible. Move the write-protection switch to the unlocked posi-
tion in order to record, erase and otherwise edit data on the card.

Turning the power on and off

CAUTION
i Turn down the volume of the sound system connected to the unit
before starting up or shutting down the unit.
i Do not wear connected headphones when turning the unit on and
off. Loud noises could damage the speakers or harm your hearing.
Before turning the power on
1.
Make the following settings on the top of the unit.
o EQ knobs w center values
o Other knobs w all the way left
o Faders w all the way down
o Switches w off (not pushed in)
2.
Minimize the output levels of audio sources and input levels of
amplifiers connected to this unit.
Turning the power on
Use the POWER switch on the back of the unit to turn its power
1.
on.
Startup screen
Meter Screen
After the unit starts and the Startup Screen is shown, the Meter
Screen will open.
NOTE
After the unit is turned on, the PAIRING indicator will blink for a set
amount of time.
2.
Turn connected input audio source devices on.
3.
Finally turn amplifiers on.
3 – Preparation
21
TASCAM Model 24