Analog Output Jack Section - Tascam 24 Manual

Analog output jack section

g MAIN OUTPUT L/R jacks
These analog outputs are XLR jacks.
o XLR (1: GND, 2: HOT, 3: COLD)
h SUB OUTPUT L/R jacks
These standard TS jacks are stereo analog outputs.
o TS (Tip: HOT, Sleeve: GND)
j FOOTSWITCH jack
This standard TS jack is for connecting a footswitch.
o TS (Tip: HOT, Sleeve: GND)
k STEREO GRAPHIC EQ faders
This 7-band graphic equalizer affects signals output from the MAIN
OUTPUT and AUX OUTPUT MON 1/2 jacks.
l AUX OUTPUT MON 1/2 jacks
These standard TS jacks are analog outputs.
o TS (Tip: HOT, Sleeve: GND)
; FX OUTPUT jack
This standard TS jack is an analog output.
When an external effect is connected, signals will not be sent to the
built-in effect.
When using an external effect, turn the built-in effect off.
o TS (Tip: HOT, Sleeve: GND)
z CONTROL ROOM L/R jacks
These standard TS jacks are stereo analog outputs.
Use these to monitor signals from the MAIN MIX L/R bus or PFL/AFL
L/R bus.
o TS (Tip: HOT, Sleeve: GND)
x PHONES jack
Use this standard stereo jack to connect stereo headphones. Use an
adapter to connect headphones with a mini plug.
Use this to monitor signals from the MAIN MIX L/R bus or PFL/AFL L/R
bus.
c PHANTOM +48V switch and indicator
Use this switch to supply +48V phantom power to the 1-2, 3-12 and
13/14-19/20 MIC input jacks on the top of the unit.
The indicator lights when the PHANTOM +48V switch is set to on.
Connect mics and output devices after turning phantom power on.
Before turning phantom power off, disconnect mics and output
devices.(see "Setting phantom power" on page 26)
2 – Names and Functions of Parts
v SD card slot
Insert SD cards in these slots.(see "Inserting and removing SD cards"
on page 21)
b MON 1/2/MAIN MIX switch
Set which output signals are affected by the equalizer.
n EQ IN/BYPASS switch
When this switch is on, the equalizer will affect the output signals set
with the MON 1/2/MAIN MIX switch.
13
TASCAM Model 24