Connecting With Bluetooth Devices; Inserting And Removing Sd Cards; Inserting Sd Cards; Removing Sd Cards - Tascam 12 Owner's Manual

3 - Preparation

Connecting with Bluetooth devices

This unit can input sound from a computer, portable audio
device or other equipment that supports Bluetooth (A2DP).
Pairing
Follow the procedures below to enable communication with a
Bluetooth device.
NOTE
Pairing also requires operation of the Bluetooth device.
Refer to the operation manual of the Bluetooth device for
procedures.
1.
Set the ASSIGN switch to "9/10" or "MAIN".
2.
Confirm that the PAIRING indicator on this unit is blinking.
If it is unlit, press the PAIRING button.
NOTE
When the unit is turned on, it automatically becomes ready
for pairing. If 2 minutes pass in pairing mode, it will end. Press
this button to reactivate pairing mode when it is disabled.
3.
Select "Model 12" (this unit) on the other Bluetooth device.
When pairing succeeds, the PAIRING indicator will stop
blinking and remain lit, and connection with the other
device will be complete.
NOTE
i Some older Bluetooth devices require the input of a passkey.
Enter "0000" in such cases.
i Pairing will automatically end if connection is not confirmed
within two minutes.
i When this unit is turned on, it will automatically try to
connect with the Bluetooth device to which it was previously
connected. At this time, pairing will automatically end after
five minutes if connection is not possible because that
Bluetooth device is not turned on or its Bluetooth function is
turned off.
Unpairing
The Bluetooth device that is currently connected can be
unpaired from the unit.
1.
Press and hold the PAIRING button for at least two seconds.
2.
This ends the pairing. The PAIRING indicator will start
blinking and the unit will be ready to pair.
32
TASCAM Model 12

Inserting and removing SD cards

Inserting SD cards

Insert an SD card into the SD card slot on the top of the unit to
enable playback and recording by this unit.
NOTE
SD cards can be inserted whether or not the unit is on or off.
1.
Open the SD card slot cover.
2.
The SD card should be inserted with its label facing left.
3.
Close the SD card slot cover.

Removing SD cards

Turn the unit off or stop operation before removing an SD card.
V CAUTION
Never remove an SD card when the unit is operating
(including recording, playing back, or writing data to the SD
card). Doing so could cause proper recording to fail, data to
be lost, and sudden loud noises from monitoring equipment,
which might damage the equipment, harm hearing or cause
other trouble.
1.
Press the SD card in gently to make it to come up.
2.
Pull the SD card out.

SD card write protection switches

SD cards have write-protection switches that prevent writing
new data to them.
If you slide the write-protection switch to the "LOCK" position,
writing will not be possible. Move the write-protection switch
to the unlocked position in order to record, erase and otherwise
edit data on the card.