Tektronix 222 Operator's Manual page 132

Checking Performance -222 DSO Operators
Description
eveled
ine-Wave
ienerator
:alibration
ienerator
ime-Mark
ienerator
2oaxial cable
'ermination
Table A-1
Test Equipment Required
Minimum
Specification
Frequency: 50 kHz to
above 10 MHz. Output
amplitude: variable
from 10 mV to 5 V p-p.
Output impedance:
5 0 a . Amplitude
accuracy: constant
within 1.5% of
reference frequency
to 20 MHz.
Standard-amplitude
signal levels (Dc and
Square wave): 5 mV to
50 V. Accuracy:
5 mV to 50 V +O.25%.
High-amplitude signal
levels: 1 V to 60 V.
Repetition rate: 1 kHz.
Fast-rise signal level:
1 V. Repetition rate:
1 MHz. Rise time: 1 ns
or less. Flatness:
f.
0.5%.
Marker outputs:
5 ns to 0.5 s.
Marker accuracy:
? 0.1%.
Connectors: BNC.
Impedance: 50
a.
Lenqth: 42 inch.
Impedance: 5 0 a
Connectors: BNC
Connectors: BNC
male-to-miniature-
probe tip.
Connectors: BNC
female-to-dual-
banana.
Use
Vertical, triggering
and bandwidth
checks.
Gain and transien.
response checks.
Horizontal
checks.
External trigger
checks.
Signal termination
Signal inter-
connection.
External trigger
check.
Example of
Test Equipment
TEKTRONIX
SG503 Leveled
Sine-Wave
Generator,
a
TEKTRONiX
PG506 Calibration
Generator.
a
TEKTRONIX
TG501 Time-Mark
Generator.
a
Tektronix Part
Number
012-0057-01
Tektronix Part
Number
01 1-0049-01.
Tektronix Part
Number
01 3-0084-02.
Tektronix Part
Number
103-0090-00.
a~equlres a TM500-serles power Module.
REV MAR 1989