Attaching The Srx3Electronics Module To A Headband; Removing The Srx3 Electronics Module From A Headband; Srx3 Compatibility - Honeywell SRX3 User Manual

Attaching the SRX3Electronics Module to a
Headband
1. Position the electronics module with the button controls facing away from
2. Insert the speaker on the back of the electronics module into the pocket on
3. Push the electronics module into the hub pocket until it is firmly seated.
Removing the SRX3 Electronics Module from
a Headband
1. Grasp the electronics module with one hand, pressing your thumb and
2. With the other hand, hold the headband by the earpiece hub.
3. Pull the electronics module away from the earpiece hub.

SRX3 Compatibility

Honeywell has tested the SRX3 Wireless Headset with the following devices and Vocol-
lect Voice Software versions. Support and compatibility of the SRX3 headset is not lim-
ited to these products, but the customer assumes risks related to untested
configurations.
Device
Vocollect Talkman A700/A700x
Vocollect Talkman A500 and Talkman A500 VMT
13
the headband.
the earpiece hub by aligning the notches on the speaker and hub pocket.
IMPORTANT
Do not squeeze the battery latches on the sides of the electronics module
while removing it from the headband. The battery may be inadvertently
released from the electronics module.
fingertips into the gap between the electronics module and earpiece hub.
Vocollect Voice Software
VoiceClient® 3.9 and newer
VoiceCatalyst® 2.0 and newer
VoiceClient® 3.8 and newer
VoiceCatalyst® 1.1 and newer
SRX3 User Guide - Preliminary