Honeywell SRX3 User Manual page 41

NOTE
does it follow any specific safety protocol. This is because the transfer
occurs over such a short range that it is extremely unlikely that the data
could be intercepted.
1. Turn on the SRX3 headset.
2. If the headset's LED is blinking blue, it is currently paired to a device. Clear
35
Data sent through near field communication (NFC) is not encrypted nor
the pairing by pressing the + and - buttons simultaneously on the SRX3
headset.
You must first obtain the operator ID by reading the headband:
1. Touch area of the SRX3 t-bar (headband) with the
symbol to center of the raised oval on the side of the device
with the
blinks green. This associates the operator's headband to
If you are
the device enabling VoiceConsole to recognize the
sharing
operator.
headsets
2. Touch the side of the A700 device that has the
at your
and the oval area of the SRX3's keypad section together,
site:
aligning the ovals on each and holding them together
steadily, until the device state (ring) indicator blinks green.
Note that there is a 30-second timeout after a headband is
recognized in step one. You must pair the electronics
module within 30 seconds from associating the headband
for full functionality.
If you are
You only need to pair the device to the SRX3 electronics module:
not
1. Touch the side of the A700 device that has the
sharing
and the oval area of the SRX3's keypad section together,
headsets
aligning the ovals on each and holding them together
at your
steadily, until the device state (ring) indicator blinks green.
site:
symbol, until the device state (ring) indicator
NOTE
If the device state indicator blinks red, the NFC read
was not successful, and you should attempt to
perform the read again .
NOTE
If the device state indicator blinks red, the NFC read
was not successful, and you should attempt to
perform the read again.
SRX3 User Guide - Preliminary
symbol
symbol