l
Attaching the SRX3 to a Hard Hat
With an SRX3 Hard-Hat Headset clip mounted on the side of a hard hat, the
headset's fork and disk assembly snaps securely onto the hat.
1. Insert the disk into the hard-hat clip from the top.
2. Slide the disk into the clip until it snaps into place.
To remove the headset, apply pressure to the tab at the top of the hard-hat clip
to release the disk from the clip. Then slide the disk up and out of the clip. It
may be necessary to use a tool, such as a flat-head screwdriver, to press the tab.
25
Position the clip on the outside of the hard hat, centered on the side of
o
the hat.
Tighten the screws to secure the bracket and clip to the hard hat.
o
Removing a clip from a hard hat
For a slotted-mount clip, push the end of the spring arms from under
o
the brim in until they fit back through the slot. It may be necessary to use
a tool to pry the arms from their installed position.
For a brim-mount clip, loosen the bracket screws and slide the brackets
o
and clip off the hard hat.
SRX3 User Guide - Preliminary