Honeywell SRX3 User Manual page 66

Hide thumbs Also See for SRX3:
Table of Contents

Advertisement

However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
RF Exposure Statement
WARNING
Honeywell Wireless products comply with International Commission on
Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal
Communications Commission Office of Engineering and Technology (OET)
Bulletin 65, Canada RSS-102, and European Committee for
Electrotechnical Standardization  (CENELEC) limits for exposure to radio
frequency (RF) radiation.
CAUTION
Exposure to Radio Frequency Radiation.
SRX3 User Guide - Preliminary
l
l
l
l
The following devices each contain an internal low-power radio:
l
Talkman™ devices and SRX/SRX2/SRX3/SRX-SL Wireless Headset.
The radiated output power of Honeywell™ devices and headsets is far
l
below the FCC/IC/EU radio frequency exposure limits.
Nevertheless, Honeywell devices shall be used in such a manner that the
l
potential for human contact with the radio antenna during normal
operation is minimized. The device should not be used if the case is
open or if the internal antenna is exposed. When not in use, the
Honeywell devices should be powered off. In addition, the device should
be worn in accordance with the instructions for this device.
Operation of this device in the band 5150–5250  MHz is only for indoor
l
use to reduce the potential for harmful interference to co-channel
mobile satellite systems.
Users should also be advised that high-power radars are allocated as
l
primary users (i.e. priority users) of the bands 5250-5350 MHz and
5650-5850 MHz and that these radars could cause interference and/or
damage to LE-LAN devices.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
60

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hbt1500-01

Table of Contents