Battery And Charger; Startup - REWIRE SECURITY 102-NANO User Manual

5.2 Battery and Charger

The battery should be charged between 8 - 12 hours before first use. Please use
the battery charging cradle provided with the 102-Nano. The battery charging
cradle is located under the soft pads holding the GPS unit in the package. This
tracker uses built-in Li-ion battery technology, and a fully charged battery can
power the 102-NANO from 16 hours up to 10 days depending on usage and
standby mode. After the first use, the battery should be charged for 2-4 hours
every time.
Warning: Do not puncture, heat or modify li-ion batteries. If at any time you
notice a battery starting to get hot or swell up, stop the charging process
immediately. Improper usage of Li-ion batteries and high temperature may
cause the battery to explode.

5.3 Startup

• Please make sure to use your 102-NANO outdoors as GPS technology will
not work accurately indoors. (GPS signals do not penetrate walls)
• Turn on the unit by pressing the "on/off" button until the indicator is on.
• In 10 to 40 seconds the device will begin to work and acquire GPS and GSM
signals. The indicator will keep flashing frequently when it is searching for
GSM signal.
• Once GSM and GPS connection is established, the LED light will start
flashing less frequently.
▪ Please note – The default password for 102-NANO is '123456'
Note: While reading the set-up commands, you will notice that some words
are separated by + or space. "+" means two words should be written without
a space, as one word. "Space" means there should be a space between two
words.
e.g.
reset+123456 means the command you should send to the tracker is
"reset123456"
▪ sleep+123456+space+shock means the command you should send to the
tracker is sleep123456 shock (there is a space between 6 and shock)