Adjusting The Appliance Door's Accessibility - Hanseatic HGTI6082C14T7735ES User Manual

Page EN-34 Installation, connection and initial commissioning
12. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
13. Transfer the drill holes from the drill tem-
plate to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
15. Remove the protective films from the
other Velcro straps and stick the Velcro
straps to the front panel using the drilling
template.
16. Attach the front panel to the appliance
door of the dishwasher using the Velcro
straps (h), hold the panel in place, and
carefully open the appliance door.
(k)
(h)
17. Remove the 4 screws from the inside of
the appliance door. Screw the front pan-
el in place at these positions using the 4
enclosed screws (k).
The front panel has been successfully mount-
(h)
ed.
Adjusting the appliance
door's accessibility
You can adjust how easy or difficult it is to
open the appliance door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force
of the appliance door by turning both lower
screws.
To make it easier to adjust
– the appliance door, turn the screws in an
anticlockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
(k)