Replacing The F-Mb21X-R Chassis Fan Tray - Haivision MB6 Installation Manual

Multichannel
Table of Contents

Advertisement

Replacing the F-MB21X-R Chassis Fan Tray

NOTE
You can remove and replace the fan tray without powering off the unit, which allows you to per-
form this maintenance procedure without stopping the service.
However, do so only if you are able to replace the fan tray within five minutes. Otherwise, we recom-
mend that you power off the unit before replacing a fan tray to avoid overheating.
Ventilation Rear Outtake(x6)
A
To replace the F-MB21X-R Chassis fan tray:
Refer to
Table 2
on page 22 to determine when to replace the fan tray. During a failure condition, the Fan LED on
the fan tray will show red.
CAUTION
Refer to
1.
Using a flat screwdriver, loosen all five captive screws (
clockwise. Note that the screws are spring-attached to the panel.
2.
If an RTU cable is connected, disconnect the cable.
3.
Remove the fan tray by pulling it away from the chassis. Set it on an antistatic surface or repack it in packing
materials.
4.
Insert a new fan tray in the slot and slide it all the way into the chassis until the captive screws make contact
with the chassis.
5.
Tighten the five screws to lock the fan tray into the slot.
6.
If the device is powered on, listen for the fans. You should immediately hear them operating. If you do not
hear them, ensure that the fan tray is inserted completely in the chassis.
7.
Verify that the Power LED is green. If the LED is not green, one or more fans are faulty. If this problem occurs,
contact your customer service representative for a replacement part.
Replacement fan trays are available from Haivision. Please contact your sales representative or email
Haivision at:
sales@haivision.com
MB6 and MB21 Multichannel Chassis Installation Guide, v2.0, Issue 01
Fan Tray Alarm Mute button
D
Figure 15: F-MB21X-R Removable Fan Tray Module
"Antistatic Precautions"
on page 5 to prevent ESD damage to the equipment.
F-MB21X-R Chassis Removable Fan Tray
Removable Fan Tray Module
(secured to enclosure using 5 screws
A-B-C-D-E
as shown)
B
E
) on the fan tray by turning them counter-
A-B-C-D-E
MB21 (21 Slot) Chassis
C
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mb21

Table of Contents