Haivision MB6 Installation Manual page 19

A = handle screw hole
E = support bracket screws (optional) F = support bracket screws (optional)
A
B
C
D
8. Loosely fasten the support brackets to the sides of the chassis with hex nut screws at (E) and (F). Slide them
into place and secure them to the back of the rack (see
NOTE If you need to further extend the support brackets, you may safely remove the two screws at po-
sition (E) on each side.
9. Using a 5/16 hex nut driver, tighten the four screws at position (F) on each support bracket.
10. If needed, tighten the two screws at position (E) on each support bracket.
11. Using a Phillips #1 screwdriver, remove slot covers (D) as required.
CAUTION Failure to properly secure or support the MB21 as described above may result in serious
damage to the enclosure and/or its contents.
12. (F-MB21X-R only) If using a system interface, insert it now. The mating connector is provided but you will
need to add your own wiring.
13. Insert the cards from the front (as shown in
MB6 and MB21 Multichannel Chassis Installation Guide, v2.0, Issue 01
B = mounting screw hole
E
Figure 13: MB21 Chassis Installation
Figure 10
C = chassis mounting flange
G = support bracket flange
Alignment of chassis mounting
G
F
red arrows in figure above; screws not provided).
on page 16).
MB21 (21 Slot) Chassis
MB21 Installation
D = slot cover
flange holes with rack
⅝"
4U
½"
Alignment
notch
19