It must be understood by the operator that a certain level of expertise is required before attempting to operate this equipment. SPECIFICATIONS Tank Volume (2X) 10 gallons / 100 lbs. abrasive or 75 lbs. of soda media. Hose Length 8 ft. x 1/2" i.d. Working Pressure 60-125 psi Air Consumption 6-25 cfm Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
SAFETY INFORMATION WARNING indicates a hazardous situation which, if not avoided, will result in death or serious injury. READ INSTRUCTIONS Thoroughly read and understand this manual before using the Eastwood Dual Blaster. Save for future reference. HEALTH HAZARD • Silica based abrasives have been linked to severe respiratory disease. Do not use sand or silica based abrasives with this blaster.
Page 4
Upper Loop Frame Moisture Trap/Inlet Valve Pressure Mounting Tabs Mounting Tabs Gauge Hardware/ Tefl on Tape Wheels Face Shield 2-1 Manifold Blast Hoses Funnel Blast Discharge Nozzle (Dead Man Valve) Front Support Loop Inlet Manifold Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Using Tefl on Tape, thread the Blast Discharge Nozzle to the 2-in-1 CAUTION: Manifold. these are tapered pipe threads and over tighten- ing will cause permanent damage. STEPS 11-12 STEPS 11-12 STEP 13 STEP 13 To order parts and supplies: 800.345.1178 >> eastwood.com...
Carefully fi ll the unit per Blaster Instructions using a screen sifter and funnel. NOTE: a suitable screen sifter such as Eastwood #50417 Sifter/Funnel must be used to capture any clumps present in the bag of media. Close all four valves and connect the air supply. DO NOT EXCEED 125 PSI. For best...
• To prevent fl ash rust or oxidation from appearing on metal surfaces after water wipe down but before painting, treat surfaces with Eastwood Fast-Etch™ #19416Z. SODA BLASTING AIR SUPPLY AND MEDIA CONSUMPTION This data is approximate and is presented for comparison use. Due to the many variables such as; compressor capacity, air line size, grade and grit size of media used, coating thickness and hardness, individual results will vary.
When you notice only air (no abrasive) is coming out of the Blast Discharge Nozzle, you can stop the air fl ow by releasing the trigger. This ensures a clean and clog-free manifold, hose, and safety trigger. Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com...
Soda/Abrasive MAINTENANCE Keep your Eastwood Dual Blaster clean, and protect it from damage. Release pressure from the tank after each use. When initially pressurizing, check for leaks at the tank top and at all hoses and fi ttings. Leaking joints may be repaired by replacing worn or damaged parts and using tefl...
This product has a one year warranty covering any manufacturing defects. Despite our strict quality control standards implemented during our manufacturing process, sometimes a product gets shipped that does not meet our specifi cations. If you have a product that does not work correctly, you must contact the Eastwood Company at 800-345-1178 to acquire a Return Authorization Number. ACCESSORIES...
Page 12
NOTES If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.544.5118 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/11737manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.345.1178...