Table of Contents
Advertisement
WARNING
In case of power cord damage,
do not attempt to repair or
replace the power cord. Contact
the manufacturer or the local
distributor.
WARNING
Avoid touching hot surfaces
while operating the machine.
CAUTION
During normal operation, the
base of the machine must be
installed or placed above the wall
socket.
CAUTION
When servicing or cleaning the
machine, make sure that the
power cord is removed from the
wall socket.
Control Board Operations
Solid State Controller
This controller has three (3) control
features:
1. Temperature – Temperature may
be set from 225°-450°F (107°-
232°C). The factory default
setting is 200°. If you would like
to change this setting, simply
follow the Controller Operation
directions.
2. Counter – Cycle counter counts
the number of applications from
1 to
9999
Counter).
3. Timer – A timer mode is
available upon special request. If
you would like to have the timer
function installed, please call
1-800-624-6717
Controller Operation
Temperature Control
1. Press the MODE button until
temperature is displayed.
2. Push and hold SET button and
simultaneously push UP ( ) or
DOWN ( ) arrow buttons to the
desired temperature setting.
For the DP2000, both the upper
and lower platens may be set to
different temperatures.
• Upper Platen: Simply
push the MODE button
until the "upper" light is
illuminated. Adjust the
temperature as noted
above.
• Lower platen: Simply
push the MODE button
until the "lower" light is
illuminated. Adjust the
temperature as noted
above.
-3-
(see additional Notes –
DP2000-1725-7/04
Advertisement
Table of Contents
