Proluxe Endurance X2 Operation Manual page 5

Dough Pressing Operations
SETTING CRUST THICKNESS
CONTROL:
*The thickness is determined by dough
weight and temperature setting on each
platen. Setting crust thickness is as
simple as the twist of a dial. The
thickness adjustment dial can be located
on the top of the DP2000. By means of
trial and error, rotate the dial until
desired thickness is obtained. **If your
platens are polished they have been
coated with Platen Saver. This product
will prevent dough from sticking and
make cleanup much easier. A sample
bottle has been included along with an
order sheet for your convenience. Note:
Never force the dial past its stop
position or damage could occur.
PRESSING DOUGH:
1. First make sure you have the
correct type electrical current or
serious damage could occur!
2. Press the Power Button in order
to turn the machine on. A green
light will illuminate above the
power button indicating that
power is in the machine.
3. Both the upper and lower platens
will heat up once you have
adjusted your digital control to
your desired setting. Note:
Different products require
different temperature settings. In
order to determine the right
temperature setting for your
product, refer to the following
table simply as a guide for
starting.
Press Only
Dough
Temp
Product
150°F
Pizza both
seconds
platens
Flour
N/A
Tortilla
No heat,
Corn must
Tortilla use wax seconds
paper
150°F
Mushi
both
Skin seconds
platens
*To achieve consistent size flour
tortillas of smaller than 10" you will
need to only press 2 at a time as shown
in the pictures included with the
manual.
Note: Keep in mind that dough
formulations may differ, and that you
may have to do some trial and error
testing of different temperatures and
platen pressure to arrive at the proper
end result for your particular product.
Also note that the finished, after-
pressing diameter of the finished dough
piece is determined by the weight of the
dough and the amount of pressure
applied to the platens.
For best results, your dough should be
proofed at room temperature before
pressing, but it will also press directly
out of your refrigerator. Flour is not
required to press a crust and should not
be dusted on any part of the machine.
-4-
Press & Par Bake
Press Press
Temp
Time Time
325°F
3 7-15
both
seconds
platens
350°F
1 quick
both
second
platens
3
N/A
3
N/A
DP2000-1725-7/04