Mpeg Nr; Dnr; Auto Brightness Sensor; Backlight Adjustment Pro - Toshiba 40SL500U Owner's Manual

MPEG NR

The MPEG noise reduction feature allows you to reduce
visible interference caused by MPEG compression.
1
From the PICTURE menu, highlight Advanced
Picture Settings and press
2
Press B or b to select Noise Reduction and press
.
O K
3
Press B or b to highlight MPEG NR.
4
Press C or c to select either Low, Middle, High or
Off and press .
O K
Note: If the Picture Mode is set to Game or PC, this feature
will be grayed out.

DNR

DNR enables you to "soften" the screen representation
of a weak signal to reduce the noise effect.
1
From the PICTURE menu, highlight Advanced
Picture Settings and press
2
Press B or b to select Noise Reduction and press
.
O K
3
Press B or b to select DNR.
4
Press C or c to select Low, Middle, High, Auto or
Off and press .
O K
Note:
• If the Picture Mode is set to Game or PC, this feature will
be grayed out.
• The differences may not always be noticeable (for the
best result use lower settings as picture quality can be
lost if the setting is too high).
Chapter 7: Picture and sound controls
.
OK
.
OK

Auto Brightness Sensor

When the Auto Brightness Sensor feature is set to On,
the TV will automatically optimize the backlighting
levels to suit ambient light conditions.
1
From the PICTURE menu, highlight Advanced
Picture Settings and press
2
Press B or b to select Auto Brightness Sensor
Settings and press
OK
3
Press B or b to highlight Auto Brightness Sensor.
4
Press C or c to select On or Off and press
Note: When the Picture Mode is set to AutoView, this
feature will be automatically set to On and grayed out.

Backlight Adjustment Pro

This feature adjusts the backlight so that it can change
to match the ambient light conditions.
1
From the PICTURE menu, highlight Advanced
Picture Settings and press
2
Press B or b to select Auto Brightness Sensor
Settings and press
OK
3
Press B or b to highlight Backlight Adjustment
Pro and press . The Backlight Control Level
OK
window will appear.
4
to display the adjustment window. Press C
Press
OK
or c to select the point and press B or b to adjust the
level. The adjustment range is from 0 to 100.
Backlight Adjustment Pro
Backlight Control Level
100
Control
Level
0
Ambient Light
5
Press to fix the adjustment.
OK
To cancel the adjustment when selecting a point,
select Cancel on the screen.
To revert the adjustments of all points to the factory
defaults, select Reset on the screen and press
Note: If the Auto Brightness Sensor is set to Off, this
feature will be grayed out.
.
OK
.
.
OK
.
OK
.
37
Cancel
Reset
OK
59
.