4.
Remove the eight #T10 Torx screws that hold the left-hand cover.
5.
Put the cover aside on a soft cloth or similar to avoid scratches.
Warning: The electronics compartment contains high voltage
6.
Remove the one or two cover plates depending on how many interface
boards you are going to install. Each plate is held by two #T10 Torx screws.
Inner cover plate
Outer cover plate
Note: Applicator interface card must be installed in the innermost position.
7.
Save the cover plate(s) for possible later use. Keep the screws.
2
Screw
(8 places)
components and wires. Do not open the electronics
compartment before the printer is safely disconnect from
any AC supply.
Applicator Interface Kit Installation Guide