Advertisement
8.
Remove the #T20 Torx screw fitted on the hexagonal spacer at the center of
the CPU board. Keep the screw.
9.
If necessary, reconfigure the interface board by fitting or removing circuits
and straps according to the descriptions of each board.
10. Attach the flat cable included in the kit to connector on the CPU board.
11. Insert the interface board with the component side facing right, as seen
from behind.
#T10 Torx screw
(2+2)
Interface board
12. Installation of one board: Attach the interface board in the innermost slot
in the printer's rear plate using the two screws left over when you removed
the original cover plate. Using the #T20 Torx screw you previously removed,
attach the interface board to the hexagonal spacer at the center of the CPU
board.
13. The kit contains two flat cables, one with two connectors for use with a
single interface board and one with three connectors for use with double
interface boards. Connect the appropriate flat cable to connector P1 on the
interface board.
Applicator Interface Kit Installation Guide
Spacer
#T20 Torx Screw
Connect to J17
3
Advertisement
