Advertisement
Message:
Cause:
Result:
Error number: 1342
Message:
Cause:
Result:
Error number: 1343
Message:
Cause:
Result:
Error number: 1344
Display Messages
These messages appear in the printer display under certain conditions when a
PRINTFEED command is run.
Message:
Cause:
Message:
Cause:
24
EAPPERR3
Applicator Error 3
AppErr3 in signal detected.
Activates event in System Health Monitor (SHM).
ERTWINEXT
RTW External Error
RTWExternal in signal detected.
Activates event in System Health Monitor (SHM).
ENODATAREADY
Dataready not enabled
Application sent a PRINTFEED in Fingerprint when the
applicator port is enabled, the style is set to I-Style or Z-Style,
and the dataready signal is not enabled.
Terminates the printfeed command without printing a label.
APPLICATOR PORT: Wait for signal
Running a PRINTFEED command blocks execution until a
startprint signal is received. The message appears when
execution has been blocked for a few seconds.
APPLICATOR PORT: Wait for reprint
Running a PRINTFEED -1,1 command blocks execution until
a reprint signal is received. The message appears when
execution has been blocked for a few seconds.
Applicator Interface Kit Installation Guide
Advertisement
