14. The flat cable should run as illustrated.
Spacer (existing)
Inner Interface Board
Screw (existing)
15. Put the cover back on the electronics compartment.
16. Connect the communication cables to the connectors on the printer's rear
plate.
17. Connect the power cord and switch on the power.
18. In case the interface provides additional serial communication ports, enter
the Setup Mode to set the proper communication parameters for these
ports.
Remarks
• The left-hand slot is the slot closest to the center section.
• Always start by fitting an interface board in the left-hand slot.
4
CPU Board
Applicator Interface
RS-232/422/485
Cable
Applicator Interface Kit Installation Guide