Error Messages - Honeywell PX4ie Installation Manual

Error Messages

Message:
Cause:
Error number: 88
Message:
Cause:
Error number: 89
Message:
Cause:
Error number: 90
Message:
Cause:
Result:
Error number: 1340
Message:
Cause:
Result:
Error number: 1341
Applicator Interface Kit Installation Guide
ERRNOAPP
Operation not allowed. Applicator Port disabled.
Application send an applicator port command to the printer
and the applicator port is disabled.
ERRAPP
Operation not allowed. Applicator Port enabled.
Application sent the Fingerprint command PORTOUT(PORT)
ON|OFF on a port used by the applicator port when the
applicator is enabled.
ERRINPUTON
Operation not allowed in Direct Protocol
Running the PORTOUT.DATAREADY ON|OFF or
PORTIN.<SIGNAL>GOSUB XXX commands when the printer
is set to using Direct Protocol.
EAPPERR1
Applicator Error 1
AppErr1 in signal detected.
Activates event in System Health Monitor (SHM).
EAPPERR2
Applicator Error 2
AppErr2 in signal detected.
Activates event in System Health Monitor (SHM).
23