Parkside PAS 4 C4 Translation Of The Original Instructions page 35

NOTE
► The vibration emission values and the noise emission values
given in these instructions have been measured in accord-
ance with a standardised test procedure and can be used
for comparison of the power tool with another tool.
► The specified total vibration values and the noise emission
values can also be used to make a provisional load estimate.
WARNING!
► Depending on the manner in which the power tool is being
used, and in particular the kind of workpiece that is being
worked, the vibration and noise emission values can deviate
from the values given in these instructions during actual use
of the power tool.
► Try to keep the load as low as possible. Measures to reduce
the vibration load are, e.g. wearing gloves and limiting
the working time. Wherein all states of operation must be
included (e.g. times when the power tool is switched off
and times where the power tool is switched on but running
without load).
PAS 4 C4
GB │ IE │
31 ■