Compliance - RainWise MK4-C Instruction Manual

Compliance

MK4-C contains approved transceiver modules:
FCC IDs : MCQ-XB3M1, XPY2AGQN4NNN and A8TBM71S2
This product was type-tested and found to comply with the limits for a class B computing device in accordance with the
specifications in Subpart J of Part 15 of FCC rules, designed to provide reasonable protection against such interference
in residential installation. We make no guarantee that interference won't occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the equipment off and on, try
correcting the interference in one or more of these ways:
» Reorient the receiving antenna.
» Increase the separation between the equipment and the receiver.
» Connect the equipment to an outlet on a circuit different from the one the receiver is connected to.
» Contact the manufacturer or an experienced radio/television technician for additional help.
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 25 cm or more should
be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations
at closer than this distance are not recommended. The antenna used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
While the antenna is detachable, the MK4-C must only be used with the supplied antenna. Use of an unapproved antenna
with regards to compliance and its ramifications will not be the responsibility of the manufacturer.
IC
MK4-C contains approved transceiver modules :
IC IDs: 1846A-XB3M1, 8595A-2AGQN4NNN and 12246A-BM71S2
This product was type-tested and found to comply with the limits for a class B computing device in accordance with the
specifications in ICES-003 and Part 15 of FCC rules.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
While the antenna is detachable, the MK4-C must only be used with the supplied antenna. Use of an unapproved antenna
with regards to compliance and its ramifications will not be the responsibility of the manufacturer.
CAUTION! This equipment is approved for mobile and base station transmitting devices only. Antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 25 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
ATTENTION! Cet équipement est approuvé pour la mobile et la station base dispositifs d'émission seulement Antenne(s)
utilisé pour cet émetteur doit être installé pour fournir une distance de séparation d'au moins 25 cm à partir de toutes les
personnes et ne doit pas être situé ou fonctionner en conjonction avec tout autre antenne ou émetteur.
| 27
C O M P L I A N C E