RainWise MK4-C Instruction Manual page 15

Station Assembly
» Rotate the anemometer mast extension until the
screw aligns with the slot in the station base, then
slide the screw all the way into the slot and hand
tighten (fig H).
» Place the screw that was removed from the
non-dimpled end of the mast (fig D) into the hole
below the station base slot and hand-tighten it
well.
» Plug the end of the cable into the anemometer.
The red side should be closest to the hub's center
and the black side closest to the hubwall (fig I).
» Slide the anemometer hub onto the anemometer
mast extension with the slot oriented in line with
the dimple as shown (fig J).
» Replace the screw that was removed from
the dimpled end of the mast to secure the
anemometer in place and handtighten with a
Phillips screwdriver (fig K).
Spare screws are provided in the zip lock bag with the
assembly tools.
Figure H
Figure I
Figure J
Figure K
S T A T I O N A S S E M B L Y
| 15