Table of Contents
Advertisement
4
Assembling Your Weather Station
Assemble the Anemometer
» Find the three screws on the anemometer mast
extension. Remove and save the small Philips screw
at the dimpled end. (fig C).
» This screw has a smaller head than the other two.
» Loosen the screw closest to the middle of the
extension by three turns.
» The non-dimpled end is marked with red tape.
Remove the screw and the tape and save the screw
for attaching to the station base (fig D).
» Pull the anemometer cable out of the station base
(fig E), and straighten the cable. Feed the cable into
the end that was marked by red tape and continue
to push the cable through the anemometer mast
extension (fig F) while sliding the extension onto
the station base so the connector comes out of the
dimpled end (fig G).
14 |
S T A T I O N A S S E M B L Y
IMPORTANT:
Complete these steps before powering up your
station to ensure the sensors initiate correctly.
Figure C
Figure D
Figure E
Figure F
Figure G
Advertisement
Table of Contents
