Advertisement
IBM Network Station model xxxx-xxx 8-bit Color Boot Monitor
>
5. Enter the following commands in order to reset the NVRAM settings to their factory defaults:
6.
> nv
7.
->> l
8.
->> s
9.
Are you sure? y
10.
->> q
11.
> se
The Setup Utility screen appears.
Booting Using NVRAM
Setting the Boot Parameters in NVRAM
From the Setup Utility, complete the following steps. If you are unsure about a particular entry, look
for more information in Chapter 10 of the IBM Network Station Manager Installation and Use
manual.
Setting NVRAM for Boot Monitors 3.0 and Above
If you are running boot monitor version 3.0 and above, proceed with the following steps. If you have
an earlier version, proceed to the
1. Choose
F2 = View Hardware Configuration
a. Verify that the flash card has been successfully configured. The type of flash card will be
listed under
been configured: see the
b. Press
Enter
2. Choose
F3 = Set Network Parameters
a. Set the
IP Addressed from
b. Set the
Network Station IP Address
c. Under
Boot Host IP Address:
values as
WinFrame, or WinCenter server. If you are using broadcast load balancing, you may leave
this field as
d. Leave the
e. Set the
Gateway IP Address
as appropriate for your network.
f. Press
Enter
3. Choose
F4 = Set Boot Parameters
a. Leave the
b. Leave the
c. Set the
TFTP Order
d. Set
LOCAL Order
e. Press
Enter
QuickOn for Windows for the IBM Network Station Release 3.0
Setting NVRAM for Boot Monitors Prior to 3.0
. If you do not see a
PCMCIA Card:
Troubleshooting
to return to the Setup Utility screen.
to
NVRAM
. Set the
0.0.0.0
Third Host
.
0.0.0.0
Configuration Host IP Address
,
Subnet Mask
to return to the Setup Utility screen.
.
value blank.
Boot File
TFTP Boot Directory
and
NFS Order
to
.
1
to return to the Setup Utility screen.
.
PCMCIA Card
section.
.
.
to reflect the IP address of the Network Station.
section, leave the
First Host
value to the IP address of your MetaFrame,
values as
, and
Broadcast IP Address
and
NFS Boot Directory
under
Boot Host Protocol
section.
entry then the card has not
and
Second Host
.
0.0.0.0
parameters
entries blank.
to
.
D
Page 5 of 13
Advertisement
