High Dump Hopper; Lift (Option); Steering Cylinder; Wheel Cv Joints - Tennant 830 Operator's Manual

MAINTENANCE
B. HIGH DUMP HOPPER LIFT (OPTION)
The hopper lift has seven grease fittings. Four
grease fittings are at the base of the two lift
cylinders, two for each cylinder. Another grease
fitting is located on the cross shaft of the hopper
lift. The last two grease fittings are located on the
roller bearings on front of the hopper lift arms.
Lubricate with Lubriplate EMB grease (TENNANT
part no. 01433--1) every 100 hours of operation.
C. STEERING CYLINDER
Each steering cylinder has one grease fitting.
Lubricate with Lubriplate EMB grease (TENNANT
part no. 01433--1) every 200 hours of operation.
D. WHEEL CV JOINTS
There are two CV joints located at each front
wheel. Lubricate with Lubriplate EMB grease
(TENNANT part no. 01433--1) every 200 hours of
operation.
E. WHEEL PIVOTS POINTS
The wheel pivots points have eight grease fittings.
Lubricate with Lubriplate EMB grease (TENNANT
part no. 01433--1) every 200 hours of operation.
F. WHEEL LEAF SPRINGS
The wheel leaf springs have twelve grease
fittings. Lubricate with Lubriplate EMB grease
(TENNANT part no. 01433--1) every 200 hours of
operation.
G. SIDE BRUSH PIVOT
Each side brush pivot has a grease fitting.
Lubricate with Lubriplate EMB grease (TENNANT
part no. 01433--1) every 200 hours of operation.
H. AUXILIARY SIDE BRUSH/ VARIO

SWEEPING BRUSHt (OPTION)

The brush pivot has two grease fittings. Lubricate
with Lubriplate EMB grease (TENNANT part no.
01433--1) every 200 hours of operation.
I. SERVICE AND PARKING BRAKES
The parking brake pivot and the brake pedal each
have one grease fitting. Lubricate with Lubriplate
EMB grease (TENNANT part no. 01433--1) every
200 hours of operation.
67
830 MM332 (3- -96)