Electric Trim Failure; Battery Overvoltage / Malfunction - Pipistrel ALPHA Trainer LSA Pilot Operating Handbook

SECTION 3
EMERGENCY PROCEDURES
1 Groundspeed indicator
3.13

ELECTRIC TRIM FAILURE

Any failure or malfunction of the electric trim can be overridden by use of
the control stick. If runaway trim is the problem, cut the circuit by pulling the
circuit breaker and land as soon as conditions permit.
1 Airplane Control
If problem is not corrected:
3 Elevator Trim Circuit Breaker
4 Throttle Lever
5 Control Stick
6 Land

3.14 BATTERY OVERVOLTAGE / MALFUNCTION

If the standard lead-acid battery is installed and overvoltage occurs (over 14.4
V), the battery must be disconnected from the system to prevent adverse
effects.
1 MASTER BAT switch
WARNING
:!
Engine restart is not possible with MASTER BAT switch in
OFF position!
The EarthX battery disconnects itself in case of over- or undervoltage.
NOTE: When EarthX battery type is installed, battery over-voltage, low volt-
age or other battery system malfunctions, are additionally indicated by the
Batt Caution light on the switch panel. The rate at which the light flashes,
indicates what type of malfunction or error is in question. Please refer to
EarthX ETX lithium battery user's manual for additional information about
how to troubleshoot any battery errors/malfunctions
PAGE
3-20
ALPHA Trainer LSA
Pilot Operating Handbook
+10 KTS for procedures, observe
winds
GRASP STICK,
MAINTAIN MANUALLY
PULL
AS REQUIRED
MANUALLY HOLD PRESSURE
AS SOON AS PRACTICAL
.
POH-162-00-40-001
OFF
PAGE REV. 0