Cleaning Interior Surfaces - Pipistrel ALPHA Trainer LSA Pilot Operating Handbook

ALPHA Trainer LSA
Pilot Operating Handbook
accumulated on the cloth, fold cloth to expose a clean area after each pass.
Remove grease or oil using a soft cloth saturated mild detergent,
1
then rinse with clean, fresh water.
Using a moist cloth or chamois, gently wipe the windows clean of all
2
contaminates.
3 Dry the windows using a dry nonabrasive cotton cloth or chamois.
Engine Compartment
NOTE: Only to be cleaned by licensed service personnel.
1 Place a large pan under the engine to catch waste.
2 Remove induction air filter and seal off induction system inlet.
With the engine cowling removed, spray or brush the engine with
solvent or a mixture of solvent and degreaser. In order to remove
3
especially heavy dirt and grease deposits, it may be necessary to
brush areas that were sprayed.
CAUTION:
Do not spray solvent into the generator, starter, or induction air
intakes.

8.7.2. CLEANING INTERIOR SURFACES

Windshield and Windows
Never rub dry lexan. Do not attempt to polish lexan.
CAUTION:
Clean lexan windows with a solvent free, none abrasive, anti-
static acrylic cleaner. Do not use gasoline, alcohol, benzene, carbon tetra-
chloride, thinner, acetone, or glass window cleaning sprays. Use only a non-
abrasive cotton cloth or genuine chamois to clean acrylic windows. Paper
towel or newspaper are highly abrasive and will cause hairline scratches.
NOTE: Wiping with a circular motion can cause glare rings. Use an up and
down wiping motion to prevent this. To prevent scratching from dirt that has
accumulated on the cloth, fold cloth to expose a clean area after each pass.
1 Wipe the windows clean with a moist cloth or chamois.
POH-162-00-40-001
PAGE REV. 0
SECTION 8
HANDLING AND SERVICING
PAGE
8-11