Mounting The Tongue Assembly - Toro 686 Operator's Manual

3
Mounting the Tongue
Assembly
Model 44856
Parts needed for this procedure:
1 Tongue assembly
2 Bracket
6 Bolt (1/2 x 2-1/2 inch)
6 Nut (1/2 inch)
6 Washer (1/2 inch)
6 Lock washer (1/2 inch)
1 Lock pin
1 Hairpin cotter pin (small)
Procedure
1. Remove the brackets, lock pin, and hardware
from the tongue attachment points of the aerator.
2. Align the tongue assembly with the aerator as
shown in Figure
3. Align the brackets on the aerator as shown in
Figure 6.
5.
Figure 5
4. Secure the tongue assembly and the brackets
with the hardware as shown in
torque the nuts to 54 to 74 N∙m (67-83 ft-lb).
1. Nut (1/2 inch)
2. Lock washer (1/2 inch)
g216322 5. Install the lock pin and secure it with the small
hairpin cotter as shown in
7
Figure 6
Figure 7
Figure 7
3. Washer (1/2 inch)
4. Bolt (1/2 x 2-1/2 inch)
Figure 8.
g216319
and
g216320