Wiring; Connecting The Power Supply For The Module; Motor Connection; Connecting Leds - Eaton XN300 Manual

30 DC motor driver module XN-322-1DCD-B35

30.3 Wiring

30.3 Wiring

30.3.1 Connecting the power supply for the module

30.3.2 Motor connection

30.3.3 Connecting LEDs

238
U
12 - 30 V
eV+
0 V
I
V+
I>
V+ 0V M+ M-
X1
Figure 124: Diagram version 2: Wiring example for XN-322-1DCD-B35
The connection to PE is established with a DIN-rail contact at the bottom of
the module.
The module and the LED drivers are powered through connection terminal
X3. The two GND pins and the two 24 pins are internally linked.
NOTICE
The rated uninterrupted current should not exceed 3.5 A.
The connection cables for the motor power supply need to be connected to
connector X1 with the output voltage for the motor.
The module can be used to control the motor's speed, output, and operating
direction. To make sure you use the right operating direction, make sure to
connect the motor with the right polarity.
The LEDs are driven with a PWM controlled current source.
￫
Please make sure to use the right polarity when connecting the
LEDs.
XN300 slice modules 06/16 MN050002 EN www.eaton.com
1+ 1- 2+ 2-
X2
+ -
M
U
24 V DC
e24
0 V
PE

24 24 0V 0V
X3
F1